In order to be able to access the DD-WRT user interface after the change has been made, you may need to change the IP address of the DD-WRT router to match that of Vilfo. Step 2: Changing the DD-WRT router IP in Vilfo Under Network Address Server Settings (DHCP), enter the following settings.Ĭonnect a network cable between the LAN port on Vilfo to the WAN port on your DD-WRT router Under Network Setup, enable the option Assign WAN Port to Switch By default Vilfo uses 255.255.0.0, if the subnet mask differs from the one shown in Vilfo, enter the new one to match the one Vilfo use Subnet Mask: Check that the subnet mask is the same one Vilfo use. Write down the IP-address shown here (By default, 192.168.1.1) Local IP Address: Verify that the IP address entered here is in the same subnet that Vilfo use. Under Network setup, check the following options: Under WAN Connection Type ➝ Connection Type, select Disabled
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |